Wallpaper Remover (Optional) - Kärcher SC 1125 Manual Del Usuario

Steam iron
Note: We recommend using the Kärcher
ironing table with active steam extraction
(2.884-933.0). This ironing table has been
designed to match your new steam clean-
er. It facilitates and, thus, accelerates the
ironing process substantially. In any case,
you should use an ironing table which is
covered with a mesh-type underlay allow-
ing the steam to pass through.
Warning
Hot steam iron and hot steam escap-
ing!Point out to other people the possible
risk of being scalded or burned. Never di-
rect the steam jet at people or animals (risk
of scalding). Do not touch any electrical
leads or combustible objects with the hot
steam iron.
Tightly insert the steam plug into the ap-
pliance connector. The plug must click
into place audibly.
Steam ironing
All fabrics can be steam ironed. Delicate
imprints or fabrics should be ironed on the
reverse or according to the manufacturer's
specifications.
Adjust the temperature control of the
steam iron within the notched range
(•••/MAX).
Once the indicator lamp on the steam
iron has gone out, the steam iron is
ready for use.
Note:The sole plate must be hot to pre-
vent the steam from condensing on the
sole plate and dripping onto the gar-
ment to be ironed.
Illustration
Press the steam button on the iron to
steam iron.
– Steaming at intervals: Press the but-
ton. A jet of steam comes out so long
as the button is pressed.
– Continuous steaming: Press the but-
ton and pull the lock backward. To stop,
push lock forward.
20
Direct the first burst of steam at a sepa-
rate piece of cloth until the steam is
emitted evenly.
You can hold the iron in an upright posi-
tion to apply steam to curtains, dresses,
etc.
Dry ironing
Note:Even if you iron without steam, there
must be water in the boiler.
Adjust the temperature of the iron ac-
cording to the garment you want to iron.
• Synthetics, silk
•• Wool
••• Cotton, linen

Wallpaper remover (optional)

You can use the wallpaper remover with
the steam cleaner to remove paper wallpa-
pers.
Place the entire surface of the wallpa-
per remover along the edge of a strip of
wallpaper. Switch on the steam supply
and allow the steam to act on the wall-
paper until it is completely soaked (ap-
proximately 10 seconds).
Move the wallpaper remover to the next
piece of wallpaper you want to remove.
Hold the steam switch pressed while
you move the tool. Lift the soaked piece
of wallpaper using a flat trowel, and pull
it off the wall. Move the wallpaper re-
mover from strip to strip, and pull the
wallpaper off in strips.
In case of woodchip wallpaper that has
been painted several times, the steam
may not be able to soak the wallpaper.
Thus, we recommend to prepare the
wallpaper using a spiked roller before
steam is applied.
Textile cleaning nozzle (optional)
Application:
To freshen up hanging textiles, such as
jackets or curtains, by means of two func-
tions:
– Defleecing garment using the thread
lifter.
- 7
EN