Bosch GBH18V-24C Instrucciones De Funcionamiento Y Seguridad página 11

Disconnect
from tool or place the switch
in the locked or off position before making any
assembly, adjustments or changing accesso-
ries. Such preventive safety measures reduce
the risk of starting the tool accidentally.
Installing SDS-plus® Accessories
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant.
Insert accessory into the chuck through the dust
shield, while twisting and pushing inward until it
locks automatically into place. Pull outward on
the accessory to be certain it is locked into the
chuck (Fig. 2).
Note: The high efficiency available from the ro-
tary hammers can only be obtained if sharp and
undamaged accessories are used. The "cost" to
maintain sharp and undamaged accessories is
more than offset by the "time saved" in operat-
ing the tool with sharp accessories.
Removing SDS-plus® Accessories
Accessories may be hot af-
ter use. Avoid contact with
skin and use proper protective gloves or cloth to
remove.
To remove an accessory, pull locking sleeve (4)
backward and pull bit forward. All accessories
should be wiped clean after removing (Fig. 3).
1605A000XG GBH18V-24C 202208.indd 11
page heading Assembly
battery pack
Fig. 2
Fig. 3
-11-
(4)
9/15/22 10:41 AM