Setting The Water Hardness - Jura ENA 4 Instrucciones De Uso

6 Permanent settings in programming mode

Setting the water hardness

18
The harder the water is, the more frequently the ENA needs to
be descaled. It is therefore important to set the water hardness
accurately.
The water hardness was set when the machine was first used. You
can change this setting at any time.
The number of symbols that are brightly lit up indicates the set
water hardness level:
Water hardness
1–7 °dH
8–15 °dH
16–23 °dH
24–30 °dH
Press the f button.
T
The & symbol lights up brightly.
Press the ] button several times until the
T
brightly.
Press the s button to enter the program item.
T
Press the [ / ] button to change the setting for the water
T
hardness.
Press the s button to confirm the setting.
E The setting must be confirmed within 20 seconds.
sss£
The symbols flash 3 times in quick succession.
Symbol(s) shown in display
s
s s
s s s
s s s £
u
symbol lights up