Rewind Starter; Storing The Machine; Checking And Replacing The Chain Sprocket - Stihl HT 56 C Manual De Instrucciones

Ocultar thumbs Ver también para HT 56 C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Rewind Starter

To help prolong the wear life of the
starter rope, observe the following
points:
Pull the starter rope only in the
N
direction specified.
Do not pull the rope over the edge of
N
the guide bushing.
Do not pull out the rope more than
N
specified.
Do not allow the starter grip to snap
N
back, guide it back into the housing
slowly – see chapter on "Starting /
Stopping the Engine."
Have a damaged starter rope replaced
by your dealer before it breaks
completely. STIHL recommends that
you have servicing and repair work
carried out exclusively by an authorized
STIHL servicing dealer.
HT 56 C

Storing the Machine

For periods of 3 months or longer
Drain and clean the fuel tank in a
N
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
carburetor diaphragms sticking
together.
Remove the saw chain and guide
N
bar, clean them and spray with
corrosion inhibiting oil.
If the unit is stored with the drive
N
tube disassembled: Fit the
protective cap on the drive tube to
avoid dirt getting into the coupling.
Thoroughly clean the machine –
N
pay special attention to the cylinder
fins and air filter.
If you use a biological chain and bar
N
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
Store the machine in a dry, high or
N
locked location – out of the reach of
children and other unauthorized
persons.
Checking and Replacing
the Chain Sprocket
Remove the chain sprocket cover,
N
chain and guide bar.
Replace the chain sprocket
a
after using two saw chains or
sooner
if the wear marks (a) are deeper
than 0.02 in (0.5 mm) since this
would reduce the life of the chain.
Use a gauge (special accessory) to
check the depth of the wear marks.
It is best to use two saw chains in
rotation with one sprocket.
STIHL recommends the use of original
STIHL chain sprockets.
English
31

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido