Checking Chain Lubrication; Fitting The Harness - Stihl HT 56 C Manual De Instrucciones

Closing the filler cap
To close the oil tank, place the filler
N
cap in position with the grip upright,
making sure the recesses are in
alignment.
Turn the filler cap clockwise as far
N
as stop.
Fold the grip down so that it is flush
N
with the top of the cap.
If the oil level in the tank does not go
down, the reason may be a fault in the oil
supply system: Check chain lubrication,
clean the oilways, contact your dealer
for assistance if necessary STIHL
recommends that you have servicing
and repair work carried out exclusively
by an authorized STIHL servicing
dealer.
HT 56 C
Checking Chain
Lubrication
The saw chain must always throw off a
small amount of oil.
Never operate your saw without
chain lubrication. If the chain runs
dry, the whole cutting attachment
will be irretrievably damaged
within a very short time. Always
check chain lubrication and the oil
level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".

Fitting the Harness

The type and style of the shoulder strap
depend on the market.
Shoulder strap
1
2
Put on the shoulder strap (1).
N
Adjust the length of the strap.
N
With the power tool attached, the
N
carabiner (2) must be at about the
same height as your right hip.
English
23