Cutting Attachment; Mounting The Bar And Chain - Stihl HT 56 C Manual De Instrucciones

Cutting Attachment

A cutting attachment consists of the saw
chain, guide bar and chain sprocket.
The cutting attachment that comes
standard is designed to exactly match
the pole pruner.
1
a
t = a : 2
– The pitch (t) of the saw chain (1),
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
– The drive link gauge (2) of the saw
chain (1) must match the groove
width of the guide bar (3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
HT 56 C
Mounting the Bar and
Chain
Removing the chain sprocket cover
2
3
Unscrew the nut and remove the
N
cover.
Turn the screw (1)
N
counterclockwise until the tensioner
slide (2) butts against the left end of
the housing slot, then back it off 5
full turns.
Fitting the chain
1
2
N
Wear work gloves to protect your
hands from the sharp cutters.
Fit the chain – start at the bar nose.
English
17