Kärcher A 2206 X Manual Del Usuario página 9

The filling level of the filter bag depends
on the dirt that is sucked in.
The filter bag needs to be replaced more
frequently while sucking in fine dust, sand,
etc.
Use a preliminary separator while sucking
in ash or rust particles (order no. 2.863-
139).
Illustration
Vacuuming hard surfaces
Insert the hard surface inlay into the floor
nozzle. The bristles should point towards
the front.
Vacuuming carpeted floors
Press both the locking flaps inwards.
Remove the hard-surface insert.
Blowing function
Use this function, for example, to blow out
leaves or dust from the garage, hobby room,
work shop, courtyard or garden.
Illustration
Connect connection hose. Open the slide
of the air regulation, and select the de-
sired blowing performance.
Wet vacuum cleaning
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full a float closes the
suction opening and the appliance works at a
higher speed. Switch off the appliance imme-
diately and empty the container.
Working with electrical power tools
Further, for A 2236 X pt:
Illustration
Electric power tools with a power consump-
tion of 100-2100 W can be connected.
(CH: 100 - 1100 W, UK: 100 - 1800 W)
A) Plug the enclosed adapter onto the
suction hose and connect the electric tool
with the connection.
or
B) Use hose Flex-Tool; attach the thicker
end directly to the surction hose and the
other end on the enclosed adapter and
connect it to the electric tool.
Illustration
Connect the mains plug of the electric
power tool to the vacuum cleaner.
Switch the vacuum cleaner to Position II
and start working.
Note: The suction turbine starts with a de-
lay of 0.5 seconds after the electric tool
has been switched on. After the electric
tool has been switched off, the suction tur-
bine will continue to run for approx. 5 sec-
onds to suck in the remaining dirt from the
suction hose.
Finish operation
Turn off the appliance and disconnect the
mains plug.
Empty the container
Illustration
Press the unlocking mechanism by foot
and remove the vacuuming device from
the chassis.
Illustration
Remove the motor casing and empty the
container.
Insert the vacuuming device in the chas-
sis - the container is self-locking.
Storing the Appliance
Illustration
Place the accessories in the appropriate
compartments at the appliance and store
the appliance in a dry room.
Transporting the device
The large wheels facilitate transportation
on stairs; hold the device at the transport
handle while doing so.
Note: Never transport the device at the
handle of the vacuuming device; risk of
tilting!
The device is to be fastened properly be-
fore transporting the device in the car.
Note: We recommend that you first re-
move the vacuuming device from the
chassis.
English 9
5
Deutsch