Sartorius Slice 50 Instrucciones De Instalación página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Operation
2
1
12
Installation Instructions Sartocon
Push the handle (2) into the initial position. The clamp is self-closing and
t
requires only a small amount of force to close.
1
The adapter (1) is pressed onto the filter holder.
y
2
Hook the notch of the inner part (2) of the filter holder onto the
t
adapter (1).
1
2
Unscrew the 3 Luer caps of filter for the retentate, permeate and feed
t
ports.
Insert the filter into the inner part of the filter holder and clip the outer
t
part onto the inner one.
Connect the 3 ports to the corresponding Luer fittings attached to the
t
outer part of the holder. To do this:
Engage the Luer tapers into the corresponding ports of the filter.
t
Screw in the Luer lock rings on the Luer fittings (2).
Make sure the Luer taper (1) is securely engaged inside the corre-
t
sponding port on the filter by giving an additional push and twist.
Make sure to hold on to the Luer connector tightly and not the com-
t
pression fitting.
Make sure that each feed, retentate and permeate port on the
t
adapter is connected to the corresponding port on the filter.
3
The QR code (3) on the filter should appear in the window of the outer
y
part of the holder.
The second permeate port next to the feed port on the filter must remain
t
capped with the Luer cap provided.
Make sure the Luer cap is done up tight on the second permeate port.
t
Follow the prompts on the screen of the control unit.
t
Slice 50 Adapter
®

Publicidad

Tabla de contenido
loading

Tabla de contenido