The Filtration Process - Sartorius Slice 50 Instrucciones De Instalación

No . Designation
8 Filter holder outer
part
9 Feed tubing
10 Filter holder inner part
11 Adapter
Connections to the Ambr
The adapter connects to the Ambr
the standard filter does: Via 3 ports corresponding to the feed, permeate
and retentate ports. The tubing provided with the accessory connects each
of these ports to the corresponding port on the filter. The filter holder allows
the filter to be attached and securely connected to the adapter via Luer
fittings.
One of the two permeate ports on the filter is not used by the adapter and
must therefore remain blanked with a Luer cap (the filters are supplied with
Luer caps on all ports). It must be ensured that the Luer cap is tight on the
unused permeate port or the filter may fail its gas tightness test.
3.1

The Filtration Process

The filtration process is unchanged when using the device with the Ambr
Crossflow module, whether it's ultrafiltration or diafiltration. Instead of going
straight into the standard filter, the fluid flows through from the adapter
feed port into the corresponding port on the Sartocon
the fluid flows out from the Sartocon
permeate ports, back into the adapter's corresponding ports and into the
Ambr Crossflow module.
®
Installation Instructions Sartocon
Device Overview
Description
Clips onto the inner part of the Ambr
Crossflow filter holder.
Connects the feed port on adapter to
the feed port on the filter.
Hooks onto the adapter.
Loads in place of the standard CF filter
to provide an interface to the module.
Crossflow Module
®
Crossflow module in the same way as
®
Slice 50 filter via the retentate and | or
®
Slice 50 Adapter
®
®
®
Slice 50 filter. Then,
®
9