Stiga PARK COMFORT Guia De Instalacion página 13

All manuals and user guides at all-guides.com
1 GENERAL
This symbol indicates WARNING.
Personal injury and/or damage to
property may result if the instructions
are not followed carefully.
You must read these instructions and
the accompanying pamphlet "SAFETY
INSTRUCTIONS" carefully, before the
assembly begin.
2 ASSEMBLY
To avoid injury and damage to people
and property, do not use the machine
until all the measures in this instruction
have been carried out..
2.1 ASSEMBLY COMPONENTS
Components that are to be used at assembly are
included in the delivery. See fig. 1.
Supplied in bag:
A plastic bag containing components, which are to
be used at assembly, are included in the delivery.
See fig. 1. The bag contains:
Pos No. Designation
A 2 Pin
B 1 Shim washer
C 1 Shim washer
D 2 Ignition key
E 2 Screw for battery
F 2 Nut for battery
G 2 Nut
H 1 Towing plate
J 2 Screw
2.2 REFERENCES
The figures in these instructions for use are
numbered 1, 2, 3, etc.
Components shown in the figures are marked A, B,
C, etc.
A reference to component C in figure 2 is written
"2:C".
ENGLISH
2.3 ENGINE CASING (2:U)
The engine casing is opened as follows:
1. Undo the rubber strap (2:V) at the front edge of
2. Carefully lift the engine casing back.
Close in the reverse order.
2.4 BATTERY
The battery is a valve-regulated battery with 12 V
nominal voltage. The battery fluid does not need to
and cannot be checked or topped up. The only
maintenance that is required is charging, for
example after extended storage.
Dimension
6 x 36
16 x 38 x 0.5
16 x 38 x 1.0
2.4.1 Charging with the engine
The battery can be charged using the engine's
M8
generator as follows:
1. Install the battery in the machine as shown
8 x 20
2. Place the machine outdoors or install an
3. Start the engine according to the instructions in
4. Allow the engine to run continuously for 45
5. Stop the engine. The battery will now be fully
2.4.2 Charging using battery charger
When charging using a battery charger, a battery
charger with constant voltage must be used.
Contact your dealer to purchase a battery charger
with constant voltage.
The battery can be damaged if a standard type
battery charger is used.
Original instructions for use
In order to access the fuel cock, battery
and engine, the machine has an engine
casing that can be opened. The engine
casing is locked with a rubber strap.
the casing.
The machine may not be operated
unless the engine casing is closed and
locked. Risk of burns and crushing
injuries.
If acid comes into contact with the eyes
or skin, this can cause serious injuries.
If any part of the body has come into
contact with acid, rinse immediately
with copious amounts of water and seek
medical assistance as soon as possible.
The battery must be fully charged
before being used for the first time. The
battery must always be stored fully
charged. If the battery is stored while
discharged, serious damage will occur.
below.
extraction device for the exhaust fumes.
the user guide.
minutes.
charged.
EN
13