Stiga PARK COMFORT Guia De Instalacion página 14

All manuals and user guides at all-guides.com
EN
2.4.3 Installation
Use the screws and the nuts (3:E, F). First connect
the red cable to the battery's positive terminal (+).
Then connect the black cable to the battery's
negative
terminal (-).
If the cables are disconnected/
connected in the wrong order, there is a
risk of a short-circuit and damage to the
battery.
If the cables are interchanged, the
generator and the battery will be
damaged.
Tighten the cables securely. Loose
cables can cause a fire.
The engine must never be driven with
the battery disconnected. There is a risk
of serious damage to the generator and
the electrical system.
2.5 SEAT
NOTE! To facilitate installation of the seat, ap-
ply a drop of oil to the four screws before screw-
ing them into the seat.
1. Remove the following components from the
seat bracket:
• 4 Nuts (for transport locking, not used).
• 4 Screws.
• 4 Shoulder washers.
2. Position the seat over the mounting in the seat
bracket.
3. Install the shoulder washers on the screws.
4. Insert the screws with the attached shoulder
washers through the slots in the seat bracket and
the holes in the seat plate. Screw the seat into
place.
Tightening torque: 9±1.7 Nm.
If the screws are tightened more than
9±1.7 Nm, the seat will be damaged.
5. Check that the seat moves easily in the slots in
the bracket.
The seat can be folded. If the machine is parked
outside when it is raining, fold the seat forward to
protect the seat cushion from getting wet.
14
ENGLISH
2.6 STEERING WHEEL
In order to minimise the axial play in the steering
column, the shim washers (5:B) and/or (5:C) must
be installed on the steering column between the
steering column jacket and the bracket as follows.
1. Install the steering column jacket on the
steering column and secure by knocking in one
of the pins (5:A) approximately 1/3 of its
length.
2. Pull the steering column jacket and the steering
column up.
3. From the outside, check whether no washers,
the 0.5 mm washer, the 1.0 mm washer or both
washers can be inserted into the gap. The
washer/washers must not be forced in, as there
must be a little axial play.
4. Pull out the pin and dismantle the steering
wheel jacket.
5. Install the washer/washers in accordance with
point 3 above.
6. Install the steering column jacket on the
steering column and secure by knocking in both
the pins fully. Use a counterhold.
2.7 TOWING PLATE
Install the towing plate (6:H) at the rear of the
machine. Use the screws and the nuts (6:J, G).
Tightening torque: 22 Nm.
2.8 QUICK-RELEASE MOUNTINGS
The quick-release mountings and installation
instructions are supplied in a separate box.
Install the quick-release mountings on the front
axles of the machine.
2.9 TYRE PRESSURE
Check the air pressure in the tyres. Correct air
pressure:
Front: 0.6 bar (9 psi)
Rear: 0.4 bar (6 psi)
2.10 ACCESSORIES
For the installation of accessories, see separate
installation guide supplied with each accessory.
Note: The cutting deck is regarded as an accessory
here.
Original instructions for use