EGO PS1000E Manual De Instrucciones página 9

H-1 Coupler on the Extension Pole
H-2 Coupler on the Power Head
NOTICE:
Once assembled correctly, the pole saw
attachment, extension pole and the power head should
not separate when pulled. Always test the connection by
pulling them. Repeat the steps above if the pieces can be
separated.
WARNING:
Failure to secure the attachment and
power head/extension pole as instructed above could
result in serious injury or death.
REMOVING THE ATTACHMENT FROM THE POWER
HEAD
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob.
3. Press the shaft release button and, with the button
depressed, pull or twist the pole saw shaft out of the
coupler to separate it from the power head or the
extension pole (if used).
4. Repeat the process to separate the extension pole
from the power head (if extension pole is used).
MOUNTING AND ADJUSTING THE FRONT-ASSIST
HANDLE
1. Stop the motor and remove the battery pack.
2. Loosen the wing nut and remove it with the clamp
bolt from the front-assist handle (Fig. I1).
Front-assist
I-1 I-4
Handle
I-2 Lock Lever I-5
I-3 Clamp Bolt
3. Press the assist handle onto the power head shaft
and turn it downward so that it points toward the saw
chain (Fig. I2).
4. Insert the clamp block and assemble the clamp bolt
with the wing nut (Fig. I3).
5. Do not fully tighten the wing nut. Adjust the front-
assist handle position so that it is between the
shoulder strap hanger and the telescopic pole sleeve
(Fig. I4). The handle should be adjusted so that your
arm is straight when using the pole saw.
6. Press down the lock lever and tighten the wing
nut so that the front-assist handle is secured from
rotation or moving on the power head shaft.
OPERATION
DANGER:
or other electric sources. If the bar and chain jams on any
electrical cord or line, DO NOT TOUCH THE BAR, CHAIN
OR THE POLE! THEY CAN BECOME ELECTRICALLY LIVE
AND MAY BE VERY DANGEROUS. Continue to hold the
pole saw by the insulated rear handle or lay it down and
away from you in a safe manner. Disconnect the electrical
service to the damaged line or cord before attempting
to free the bar and chain from the line or cord. Contact
with the bar, chain, other conductive parts of the pole
saw, or live electric cords or lines will result in death by
electrocution or serious injury.
WARNING:
to make you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
glasses with side shield. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
the product when you are assembling parts, making
adjustments, cleaning, transporting or when not in use.
Removing the battery pack will prevent accidental starting
that could cause serious personal injury.
WARNING:
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
Wing Nut
recommended can result in serious personal injury.
Before each use, inspect the entire product for damaged,
Clamp Block
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced.
APPLICATIONS
You may use this product for the purposes listed below:
◾
Limbing
◾
Pruning
NOTICE:
purpose. Any other use is deemed to be a case of misuse.
FILLING OILTANK WITH BAR AND CHAIN LUBRICANT
WARNING:
near the oil or the pole saw. Oil may spill and cause a fire.
56 VOLT LITHIUM-ION CORDLESS POLE SAW— PS1000E
Never cut near power lines, electric cords,
Do not allow familiarity with this product
Always wear safety goggles or safety
Always remove the battery pack from
Do not use any attachments or
The tool is to be used only for its prescribed
Do not smoke or bring any fire or flame
EN
9