Assembly; Operation - Ryobi PSBCK01K Manual Del Operador

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
PSBDD01
Drilling and driving screws in all types of wood products
(lumber, plywood, paneling, composition board, and hard
board), ceramics, plastics, fiberglass, laminates, metals;
Driving screws into wood and drywall with screwdriver bits
PSBID01
Driving and removing screws/lag bolts; tightening screws,
nuts, and bolts
OVERLOAD PROTECTION
When the tool is forced or overloaded, the Li-ion battery
pack will automatically shut off the tool. To reset the tool,
release the trigger and resume operation. If the tool still does
not resume operation, remove and reinsert the battery. Do
not force the tool.

ASSEMBLY

OPERATION

PSBDD01 DRILL-DRIVER / PSBID01 IMPACT DRIVER
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
HIGH TEMPERATURE PROTECTION
Li-ion battery packs are equipped with a high temperature
protection feature that automatically deactivates the tool
when it is overheated. To resume operation, allow the battery
and tool to cool and then squeeze the trigger.
INSTALLING/REMOVING BELT HOOK OR BIT
HOLDER (NOT INCLUDED)
See Figure 1, page 11 (PSBDD01).
See Figure 1, page 12 (PSBID01).
The belt hook and bit holder are interchangeable. They may
be installed on either side of the base.
 Align hole in belt hook or bit holder with hole in tool's
base.
 Install screw to secure belt hook or bit holder in place.
 To uninstall, remove screw and then belt hook or bit
holder.
6 - English