Bemer Therapy System Evo Instrucciones De Uso página 37

Expert mode enables the selection of user-created therapy programs
(for time and intensity, see chapter 8.2.6).
The Expert-mode programs are not visible until they have been created
(see chapter 8.2.6).
The plus Signal is activated by default before the start each treatment and must be
deactivated if not required. The plus Signal cannot be deactivated during an ongoing
treatment.
8.3.3 Sleep program
Once the "Sleep program" therapy type has been selected, the alarm time can be set. Do not set the
alarm time until you are ready to go to sleep.
z Press <Sleep>.
z If necessary, switch the connected port to A1/A2.
Sleep – Alarm time opens.
Alarm time 1 and treatment duration
A1 B.Bed A2
Sleep – Alarm time –
1 2 4
07:30
3
08:00
A1 A2 7 6
BACK NEXT
ALARM
Example: setting the alarm time
z Press 3 < > to adjust the hours.
z Increase or decrease the displayed hours via
z Press 5 < > to adjust the minutes.
z Increase or decrease the displayed minutes via
z Select 7 <Alarm> on/off.
2 are displayed.
23:30
5
<+> and <−>.
4
<+> and <−>.
4
72
A green circle means the sleep program can be activated. The red circle indicates
that the set sleep time exceeds the minimum or maximum permitted sleep time.
The therapy time can only be set and activated for between 6 and 10 hours of sleep. From
6 hours, a green circle appears around the application time, indicating that
the application can be started.
z Press 6 <Next>.
z Sleep opens.
A1 B.Bed A2
Sleep –
08:00:00
23:30 01:30 ... 05:30 07:30
1 2 3
A1 A2
BACK START
ALARM MUSIC
Starting and displaying the sleep program
z Select 1 <Alarm> on/off.
z Select 2 <Music> on/off.
z Press 3 <Start> to start the therapy.
z Press <Stop> to end the therapy prematurely.
ES NL IT FR
23:30
73
DE EN