Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The compressor does not
start immediately after
pressing the "Extra Freeze"
or "Extra Cool", or after
changing the temperature.
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily.
The lamp does not work.
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Possible cause
The Extra Freeze function is
switched on.
The Extra Cool function is
switched on.
The compressor starts after
a period of time.
The appliance is not level‐
led.
You attempted to re-open
the door immediately after
closing.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
During the automatic de‐
frosting process, frost melts
on the rear plate.
Door was opened too fre‐
quently.
ENGLISH
Solution
Refer to "Extra Freeze func‐
tion" section.
Refer to "Extra Cool func‐
tion" section.
This is normal, no error has
occurred.
Refer to installation instruc‐
tions.
Wait a few seconds between
closing and re-opening of
the door.
Close and open the door.
Contact the nearest Author‐
ized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet‐
ter.
Refer to "Control panel"
chapter.
Set a higher temperature.
Refer to "Control panel"
chapter.
Set a higher temperature.
Refer to "Control panel"
chapter.
This is correct.
Open the door only when
necessary.
23
Publicidad
