Publicidad
Idiomas disponibles
Idiomas disponibles
Disconnect battery pack from tool before making any assembly, adjustments
or changing accessories. Such preventive safety measures reduce the risk of
starting the tool accidentally.
Fig. 3
(22)
(5)
(18)
Attaching the Blade
Only use 5-3/8" (136mm)
metal cutting blades recom-
mended in this manual. Do not use abrasive
wheels. Only use a blade rated 4350 rpm or
greater. Using blade not designed for the saw
may result in serious personal injury and prop-
erty damage.
1. Press and hold the Shaft Lock Button (Fig. 3,
1). Turn Blade Stud (18) with the provided
wrench (5) counter-clockwise (Fig. 3, direc-
tion
) and remove Blade Stud (18) and
1
Outer Washer (19).
Note: The Blade Wrench is stored near the bat-
tery pack compartment (28).
2. Make sure the saw teeth and arrow on the
blade point in the same direction as the ar-
row on the Lower Guard (Fig 3, 23).
page heading
Assembly
(28)
(19)
(20)
(21)
(23)
(24)
(2)
3. Retract the Lower Guard (23) all the way up
into the Upper Guard (2). While retracting
the lower guard, check operation and condi-
tion of the LOWER GUARD SPRING.
4. Slide Blade (20) through slot in the foot and
mount it against the Inner Washer (21) on
the Blade Shaft (22). Be sure the large di-
ameter of the Outer Washer (21) lays flush
against the blade.
5. Reinstall the Outer Washer (19) and tighten
Blade Stud (18) finger tight. Press Shaft
Lock Button (1) to tighten Blade Stud (18)
clockwise (Fig. 3, direction
with the provided Blade Wrench (5).
Do not use wrenches with longer handles, since
it may lead to over tightening of the blade stud.
-13-
(1)
) 1/8 turn (45°)
2
Publicidad
