Publicidad
Idiomas disponibles
Idiomas disponibles
Inserting and Releasing Battery Pack
Use only Bosch batteries
recommended in the bat-
tery/charger list, included with your tool. Us-
ing other types of batteries may result in per-
sonal injury or property damage.
Slide charged Battery Pack (Fig. 1, 9) into the
housing until the Battery Pack locks into position.
Your tool is equipped with a secondary locking
latch to prevent the battery pack from complete-
ly falling out of the handle, should it become
loose due to vibration.
To remove the Battery Pack (9), press the Bat-
tery Pack Release Button (8) and slide the Bat-
tery Pack out. Press the Battery Pack Release
Button (8) again and slide the Battery Pack (9)
completely out of tool housing.
Vari-torque Clutch
This clutching action is provided by the friction
of the Outer Washer (Fig. 3, 19) against the
Blade (20) and permits the Blade Shaft (22) to
turn when the blade encounters excessive re-
sistance. when the Blade Stud (18) is properly
tightened (as described in no. 5 of Attaching
the Blade section), the blade will slip when it
encounters ex cessive resistance, thus reducing
saw's tendency to KICKBACK.
One setting may not be sufficient for cutting all
materials. If ex cessive blade slippage occurs,
tighten the blade stud a fraction of a turn more
(less than 1/8 turn). OVERTIGHTENING THE
BLADE STUD NULLIFIES THE EFFECTIVENESS
OF THE CLUTCH.
Brake Action
Let the saw blade come to a
complete stop before set-
ting the tool down. The brake action of this cir-
cular saw is not intended as a safety feature.
Unintended contact with a rotating saw blade
can cause property damage and/or personal in-
jury.
page heading
Assembly
Operation
braking action is initiated ONLY by the release
of the trigger switch and in a tool that has pow-
er available. When electrical power is lost due
to a discharged battery or other causes, the
electric brake will not operate and the motor
will gradually slow down. Unexpected run down
time may cause property damage and/or per-
sonal injury.
Your circular saw is equipped with an automatic
electric brake, which is designed to stop the
saw blade from spinning in approximately two
(2) seconds after you release the trigger switch.
This feature helps improve jobsite productivity.
Braking starts once the power is turned off. The
brake requires a charged battery to function.
Stopping time will vary depending on, among
other factors, saw blade used, and number of
actuations. The electric brake of your circular
saw has been designed for a high degree of reli-
ability, but unexpected circumstances such as
contamination or failure of the motor's compo-
nents can cause the brake to not activate. If the
tool operates but the brake does not consistent-
ly stop the blade in about 2 seconds, DO NOT
use the circular saw and have it serviced by a
Bosch Factory Service Center or Bosch autho-
rized service facility.
-14-
(4)
(10)
Know the charge state of
your battery. The electric
Fig. 4
Publicidad
