Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
TOOL WILL NOT START
1. Battery pack not charged.
2. Battery pack not installed properly.
3. Battery pack temperature is too hot or cold
for operation.
4. Electronic Motor Protection turned tool off.
5. Burned out switch.
6. Trigger does not turn tool on.
EXCESSIVE VIBRATION
1. Blade out of balance.
2. Workpiece not clamped or supported properly.
CUT BINDS, BURNS, STALLS MOTOR WHEN RIPPING
1. Dull blade with improper tooth set.
2. Warped sheet.
3. Blade binds.
4. Improper workpiece support.
BLADE SLIPPING
1. Tool does not cut workpiece.
Troubleshooting
page heading
REMEDY
1. Charge battery if needed.
2. Confirm battery is locked and secured to the tool.
3. Let battery sit a few minutes or until it reaches normal
operating temperature.
4a. Remove battery an replace.
4b. Let tool sit a few minutes or until it reaches normal
operating temperature.
5. Have switch replaced by an Authorized Bosch Service
Center or Service Station.
6. Disengage Safety Switch as described on page 16.
1. Discard Blade and use different blade.
2. Clamp or support workpiece as shown on pages 18
and 20.
1. Discard blade and use a different blade.
2. Make sure concave or hollow side is facing "DOWN"
feed slowly, see page 19.
3. Assemble blade and tighten Vari-Torque clutch per
"Assembly Instructions", see page 13.
4. Clamp or support workpiece as shown on pages 18
and 20.
1. Assemble blade and tighten Vari-Torque clutch per
"Assembly Instructions", see page 13.
-22-
Publicidad
