Emos P5732 Manual De Instrucciones página 4

Pairing the Button with the Chime
1. Remove the rear cover of the button by inserting a screwdriver into the
hole on the bottom side. Insert a 3 V battery, type CR2032, into the but-
ton. When inserting a battery, make sure to observe the correct polarity!
Replace the battery cover.
2. Insert 3× 1.5 V AAA alkaline batteries into the chime (a red LED will flash).
When inserting the batteries, make sure to observe the correct polarity.
Do not use 1.2 V rechargeable batteries; the lower voltage may prevent
the chime from working. Replace the battery cover. If you wish to power
the chime via the micro USB port, connect the micro USB cable to a power
adapter (not included) and the chime, then plug the adapter into a socket.
3. Long press the
light up red. The chime will switch to self-learning pairing mode which
lasts for 30 seconds. During this time, press the ring button. The chime
will ring, the LED on the chime will turn off, and the button is now paired
with the chime. This automatically ends self-learning mode.
4. To pair multiple buttons, repeat the process for each button from step 1.
Note: The chime has an internal memory where it stores the codes of the
currently paired buttons. Therefore, there is no need to pair buttons again
after replacing batteries. Every time batteries are changed in a doorbell, the
currently set ringtone will sound.
Wiping the Memory of Paired Buttons
1. Remove the batteries from the chime or disconnect the micro USB cable.
2. Press and hold the
3. Insert batteries back into the chime or reconnect the USB cable (while
still holding the
4. A red LED will light up on the chime within approximately 5 seconds.
5. Release the
6. This erases the memory of all paired buttons.
Ringtone Selection
1. Repeatedly press the ringtone change button
2. Each press of the button will play a different ringtone. The last ringtone
played is the one that will be used.
Setting the Bell Volume
You can set 4 volume levels.
1. Repeatedly press the
2. The volume that played last is the one that is now set.
Setting Ringing Mode
Simultaneously press the
Each press sets a different ringing mode:
1. Acoustic + optical signalisation
button (for ca. 5 seconds); the LED on the chime will
button.
button).
button; the red LED will turn off.
button.
and button on the chime.
4
located on the chime.