Emos P5728 Manual De Instrucciones página 4

3. Then, long-press the pairing button
The chime LED will light up; release the
The chime will switch to self-learning pairing mode which lasts for
25 seconds.
During this time, press the ring button. The chime will ring and the button
is now paired with the chime.
This automatically ends self-learning mode.
4. Re-assemble the button.
5. To pair multiple buttons, repeat the process for each button from step 1.
Note: The chime has an internal memory where it stores the codes of the
currently paired buttons.
Therefore, there is no need to pair buttons again after replacing batteries.
Every time batteries are changed in a doorbell, the currently set ringtone
will sound.
Wiping the Memory of Paired Buttons
Insert 2 AAA batteries into the doorbell, then press and hold the
the remaining third AAA battery into the doorbell. The doorbell's LED will flash
and then remain lit. Release the
the memory of all paired buttons.
Ringtone Selection
1. Repeatedly press the ringtone change button
2. Each press of the button will play a different ringtone. The last ringtone
played is the one that will be used.
Setting the Bell Volume
Repeatedly press the
Each press changes the volume 100 % – 75 % – 50 % – 25 % – 0 %.
Installation of the Doorbell (Transmitter) Button
1. Begin by pairing the button with the chime.
2. Before installation, check that the pair works reliably in the chosen spot.
3. Remove the rear cover of the button by inserting a screwdriver into the
hole on the bottom side.
4. Use the double-sided adhesive tape (included) or two screws to fix the
rear portion of the cover to the wall. See Button Description/Installation.
Although the button is weather resistant, choose a location where it is
protected, e.g. in a wall recess.
5. Re-assemble the button.
6. Press the button to ring the chime. Pressing is accompanied by LED
illumination indicating the button has sent a radio signal. The chime plays
the selected ringtone.
button; the LED will turn off. This will erase
button on the chime.
4
on the chime for ca. 5 seconds.
button.
or located on the chime.
button. Insert