Publicidad
Step 24
We recommend using the SAFETY STRAP (60M) for added stability.
å
NOTE: Do not turn the SAFETY DRYWALL ANCHOR (61M) into a wall stud. If you prefer to fasten the SAFETY
å
STRAP (60M) to a wall stud, go to your local hardware store for proper hardware.
INSTALLATION INSTRUCTIONS: (Also available at www.yl-anchors.com)
å
1. Insert the SAFETY DRYWALL ANCHOR (61M) through the WASHER (13M) and one end of the SAFETY STRAP (60M).
2. Using a Phillips screwdriver or a hand drill, press screw slightly onto the drywall.
3. Apply pressure; turn the screw until a pilot hole is made and the nylon sheath slips through.
4. Turn the screw until it is fl ush against the wall and you feel a fi rm resistance.
5. Continue to turn until the screw starts spinning freely.
Carefully cut out the top perforated hole in the BACK (I). Insert the other end of the SAFETY STRAP (60M) through this
å
hole, then use a BLACK 9/16" LARGE HEAD SCREW (1S) through the SAFETY STRAP and into the pre-drilled hole in the
underside of the TOP.
NOTE: Before moving your unit to a diff erent location, unscrew the SAFETY DRYWALL ANCHOR (61M) from your wall.
å
The nylon sheath will remain behind your wall.
www.sauder.com/services
I
418231
13M
61M
60M
BLACK 9/16" LARGE HEAD SCREW
(1 used in this step)
1S
Page 29
Publicidad
