Publicidad
Step 25
To insert the drawer into your unit, tip the front of the drawer down and drop the rollers on the drawer behind the rollers on
å
the unit. Lift the front of the drawer up and slide it into the unit.
To insert the Roll-out drawer into your unit, line up the EXTENSION SLIDES on the drawer with the EXTENSION RAILS on
å
the unit and push the drawer into the unit until the drawer is fully inserted. The drawer will push in hard until it is all the way
in, then it will slide in and out easier.
NOTE: The front of the Roll-out drawer will fl ip up for easier access to your audio/video equipment. Using the KNOBS, lift
å
up on the FLIP-UP DOOR (J) until it is above the drawer.
Apply the WARNING LABEL (1L) to the TOP (C). You should be able to read the label when the TV is removed from the
å
unit. When the TV is in place, it should hide the label. Peel off the backing and apply the label as shown in the diagram.
NOTE: This is a permanent label intended to last for the life of the product. Once applied, do not try to remove it.
å
Push a CAM COVER (13P) onto each HIDDEN CAM.
å
J
K
Page 30
C
50 lbs.
35 lbs.
35 lbs.
1L
418231
WARNING
Never use this furniture with a TV that is too
large or too heavy. Severe injury or death can
occur. The TV and furniture will be unstable
and may tip.
- The TV must weigh less than 50 lbs.
- The base of the TV must be able to sit
completely on this shelf.
13P
(4 used)
To cover HIDDEN CAMS
Place the roller on the SLIDE
behind the roller on the RAIL.
www.sauder.com/services
Publicidad
