Publicidad
Step 3
Separate the EXTENSION SLIDES (V) from the
å
EXTENSION RAILS (U) as shown in the enlarged diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (U) to the ENDS (A and B).
å
Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the END. Turn a SCREW into
this hole.
Push the black lever in and pull the SLIDE from the RAIL.
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Open end
Edge with
HIDDEN CAMS
Page 8
V
U
B
U
U
418231
Remember:
Righty tighty.
Lefty loosey.
Open end
Edge with
HIDDEN CAMS
A
www.sauder.com/services
Publicidad
