SURE petcare Microchip Pet Door Manual De Instrucciones página 7

Programming your pet into the pet door
To start using your pet door, you need to program your pet's microchip ID into the pet door.
This process is only required once for each pet, as their ID will be stored in the pet door's
memory. Follow the simple step-by-step guide to carry out this process. We strongly advise
doing this prior to fitting, however it is possible to program once already fitted following
the same steps detailed below.
If using a Sure Petcare RFID Collar Tag, the collar tag can be held in the tunnel
to complete this step. Make sure you are not wearing jewellery as this may
cause interference.
If you're adding multiple pets, avoid mixing up microchip IDs by adding each
one separately.
Remove the button cover to reveal the six buttons on the
front of the pet door. Press the 'Add a Pet' button once to
activate the 'Add a Pet' mode.
When the door is in 'Add a Pet' mode, the catches at the
front of the pet door will drop (you will hear a click) and
the display on the LCD screen will start flashing.
The pet door is now waiting for your pet. Place some dry
food or a treat inside the tunnel as close to the clear plastic
door as possible. The aim is to encourage your pet to put
its head inside the tunnel as if it were coming home.
When your pet enters the tunnel to eat the food, the sensors
inside the product activate and the pet door saves the chip ID.
Once the microchip has been successfully added, the screen
display will show the number that has been assigned to the
pet, e.g. 01 for the first pet you add and 02 for the second
etc. When your pet removes its head from the tunnel the
catches on the door will move up again and the screen will
go back to normal.
EN
7