Publicidad
Idiomas disponibles
Idiomas disponibles
EN
After working, wash your hands and
clean all of clothing. You know that
the remaining pesticide can stain
what you touch.
MAIN APPLICATION
Mist-Duster is one kind of portable,
flexible and efficient machinery for
plant protection. It is mainly used in
prevention and cure of diseases and
pests of plants such as cotton, rice,
wheat, fruit trees, tea trees, banana
trees, etc. It can also be used
for chemical weeding, epidemic
prevention, sanitation protection in
cities, vegetable protection, etc.
MAIN FEATURES
This machine adopts gear structure
to decrease speed, so it is very
durable. The main part is the
plunger pump of two directions'
type.
The structure is simple and
compact, so it is easy for the
maintenance.
This machine has high pressure,
big flow and good efficiency, so the
protection effect is very obvious.
The main spraying parts are three
nozzles, which are developed and
only adopted by our factory in our
country.
So the spraying range is wide.
ASSEMBLY FOR VARIETIES
OF OPERATING CONDITION
Assembly for spraying.
Remove the tow wing nuts fixed on
the chemical tank and take down
the tank.
Change dusting lid plate for
spraying lid plate, then assemble
the chemical tank and screw down
wing nuts as shown in Fig.1.
1. Nut.
2. Dusting Plate.
Fig 1.
ASSEMBLY IN CHEMICAL
TANK
Remove the lower cover of chemical
tank, change into the pressing lid
which is connected with rubber tube
(do not forget to put on the sealing
ring, as Fig.3.).Connect the lid to
the rubber tube as shown in Fig.2.
1. Sealing washer.
2. Lid.
3. Filter net.
4. Tube.
5. Rubber tube.
6. Lower lid.
7. Spraying plate.
Fig 2.
Fig 3.
C. Connect spraying pipe to the
machine as shown in Fig.4.
1. Hose.
2. Cock assembly.
3. Connector.
4. Pipe.
5. Ultra low-volume nozzle.
6. Constant nozzle.
Fig 4.
ASSEMBLY FOR DUSTING
Remove the chemical tank, take
down the inlet rubber tube, outlet
rubber tube, suction strainer,
spraying lid plate, pressing lid
and union, change for lower lid of
chemical tank, then connect the
dusting pipe as Fig.5.
1. Clip.
2. Connector.
3. Bent pipe.
4. Connecting pipe.
5. Y-pipe.
6. L-pipe.
17
Publicidad
