Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Fig 5.
Remove the spraying pump and
plastic connector as shown in Fig.6
and assembly in pulling rod as
shown in Fig.7.
1. Spraying pump.
2. Plastic connector.
Fig 6.
1. Pin.
2. Rocker shaft.
3. Pulling rod.
4. Nut.
5. Connector.
6. Dust rod.
Fig 7.
18
ANTI-ELECTROSTATIC
INSTALLATION
Dusting or spreading granules
chemical may cause the
electrostatics that is related to
the factors, such as the kind of
chemicals, air temperature, air
humidity, etc. In order to prevent
ectrostatics, please use the
attachment-insurance chain.
When the air becomes dryer,
the electrostatic is more serious,
in particular when the long
membranous tube for dusting
and granules spreading is used,
electrostatic will often happen.
Please pay attention.
One end of insurance chain is
inserted into jet pipe, vibrated freely
and touched to the ground.
Connect another end with
conducting wire, then fix conducting
wire and insurance chain on bend
pipe by screw.
Assembly as Fig.8.
Fig 8
ROTATION
Check
Checking whether the spark plug
and all the connection are tightened.
Checking whether the cooling air
channel is clogged. If so, the engine
will be over heated.
Checking whether the air filter is
dirty. If so, the dirt will reduce the
amount of air drawn in. So the
engine doesn't run well and waste
fuel.
Check whether the gap of the
sparking plug is 0.6～0.7mm.
Pull the starter 2 or 3 times, check
whether it rotates normally.
FUELING
The fuel for this machine is a
mixture of gasoline No.70 or
No.90 and 2-stroke oil. The ratio
between them is determined by the
oil instruction. Incorrect gasoline,
oil and mixture may damage the
engine.
Never fuel the engine when it is hot
or running.
When fuel, never take away the
strainer.
ADDING CHEMICAL
During spraying operation, while
adding chemical, the switch must be
shut, see Fig.9.
During dusting operation, dusting
valve throttle and fuel lever
should be on the bottom position,
other-wise, the machine will have
chemical out. As powder chemical
can easily become block, so the
chemicals should not be in the
chemical tank for a long time.
While spraying, the chemical tank
lid should be turned on tightly. After
adding powder chemical, please
clean the screw of the chemical tank
mouth, then turn on the lid tightly.
SHUT
Fig 9
OPEN
Publicidad
