revised 10/2022
OPERATING THE MACHINE
WARNING!
Be sure you understand the operator controls and their functions.
While on ramps or inclines, avoid sudden stops. Avoid abrupt sharp turns. Use low speed down ramps.
STARTING THE MACHINE
1
Follow the instructions in "Preparing the Machine for Use" section of this manual and verify the following;
• Batteries are fully charged.
• Exterior of machine is free of damage. Report any damage to your supervisor.
• This point only for machines with Mechanical Brake. Check the Brake Pedal (37). The pedal should be fi rm. If the brake pedal reaches its
end of travel in the slot while being pressed, DO NOT OPERATE THE MACHINE. Report all defects immediately to service personnel.
• Proper brushes are correctly installed.
• Squeegee is installed.
• Solution tank is full.
• Recovery tank is empty.
• Ensure that area to be scrubbed is clear of obstacles that are not fi xed, such as hoses, buckets or pails, boxes, electrical cords, carts,
pallets, etc.
WARNING!
Do not dispense fl ammable cleaning agents, operate the machine on or near these agents, or operate in areas
where fl ammable liquids exist.
2
See Figure 8-2. While seated on the machine, adjust the seat and steering wheel to a comfortable operating position using the adjustment
controls found on the seat and Steering column Tilt Adjust (16).
3
Place the Magnetic SmartKey (W) onto the SmartKey Reader (A). Press the Power Switch (B). This will activate the Display (C).
4
Reference the Battery Condition Indicator (C3) and Hour Meter (C1) before proceeding.
5
To transport the machine to the work area, apply even pressure with your foot on the front of the Drive Pedal (3) to go forward or the rear of
the pedal for reverse.
6
Adjust machine speed by varying the pressure on the Drive Pedal (3).
STOPPING THE MACHINE
1
Stop the machine by releasing the Drive Pedal (3).
2
This step only for machines with Mechanical Brake.
After releasing the Drive Pedal, the Brake Pedal (37)
can be pressed to help stop the machine.
NOTE: The brake pedal actuates the mechanical
brake system located on the rear wheels.
3
ONLY IN THE EVENT OF AN EMERGENCY!
To stop all machine functions immediately, press the
Emergency Stop (U).
• The display will show Emergency Stop Activated
Indicator (C20).
• To reset the machine functions, rotate the
emergency stop clockwise.
4/2016
INSTRUCTIONS FOR USE
FIGURE 8-1
56091161 - SC6000
ENGLISH - A
3
37
A - 27