SOMFY Sunea 40 Solar io Instrucciones página 7

Sunea 40 Solar io
CAUTION
• Ensure battery is fully charged prior to installation on site.
• Do not unplug the battery when the drive works.
• For the purposes of recharging the battery, only use the detachable supply unit provided with this drive.
2.2.1.Wiring with connectors
1] Wire the 4-pin drive connector (j) to the 4-pin cable Y connector (k).
2] Wire the 2-pin cable Y connector (m) to the 2-pin battery connector (o).
3] Wire the 4-pin cable Y connector (p) to the 2-pin solar panel connector (q).
2.2.2.Wiring without connectors
Wire the drive to the Oximo WireFree Battery, Oximo WireFree Battery Stick or Somfy 12V NAKED BATTERY battery (r)
and the 3.2 W Solar Panel solar panel (s), following the figure:
▪ L = Blue wire (+)
▪ N = Brown wire (-)
▪ SP = Yellow wire.
The wires must have a minimum conductor cross-section of 0.5 mm
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
j k
2
.
r
L
N
N
SP
SP
L
p q
m o
s
EN
7