SOMFY Sunea 40 Solar io Instrucciones página 9

Sunea 40 Solar io
2.3.1.Pre-programming the control point
1] Connect the drive to the battery, referring to Wiring.
2] Press the Up and Down buttons simultaneously on the control point:
ð The motorised product moves up and down.
g The control point is pre-programmed.
2.3.2.Checking the direction of rotation
Press the Up button on the control point:
a] If the motorised product rises, the direction of rotation is correct: move onto
section Setting the end limits.
b] If the motorised product lowers, the direction of rotation is incorrect: move onto
the next step.
b1] Press the my button on the control point until the motorised product moves up
and down: The direction of rotation has been modified.
b2] Press the Up button on the control point to check the direction of rotation.
2.3.3.Setting the end limits
2.3.3.1. Setting the end limits in semi-automatic mode (for a motorised product with
upper end stops)
The lower end limit must be set in manual mode, and the upper end limit is set
automatically:
1] Lower the motorised product to the desired position by pressing the Down
button.
ð Pressing and holding the Down button for more than 2 seconds will lower
the motorised product in one continuous movement.
2] Stop the motorised product at the desired point.
3] If necessary, adjust the position of the motorised product using the Up or
Down buttons.
4] Press the my and Up buttons simultaneously until the motorised product
rises.
ð The lower end limit is set.
5] Press the my button briefly to stop the motorised product.
6] To confirm the end limits, press the my button until the motorised product
briefly moves up and down.
g The end limits are programmed.
2.3.3.2. Setting the end limits in manual mode
NOTICE
The end limits can be set in any order.
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
1] 2]
ON
]
a
]
b
b1] b2]
1] 2]
3] 4]
5] 6]
EN
9