SOMFY Sunea 40 Solar io Instrucciones página 8

EN
2.3.Commissioning
Identifying the steps to follow
The end limit setting depends on the type of motorised product:
For a motorised
product with upper end
stops
The end limits must be set in semi-automatic
mode.
Step 3 a:
Setting the end limits in semi-automatic mode
(for a motorised product with upper end stops)
[⇢ 2.3.3.1.]
NOTICE
For information about the compatibility of the drive with the motorised product and accessories, contact the product
manufacturer or Somfy.
8
Step 1: Pre-programming the control point [⇢ 2.3.1.]
Step 2: Checking the direction of rotation [⇢ 2.3.2.]
Step 4: Programming the control point [⇢ 2.3.4.]
Use and maintenance [⇢ 3.]
For a motorised
product without upper
end stops
The end limits must be set in manual mode.
Step 3 b:
Setting the end limits in manual mode [⇢ 2.3.3.2.]
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
Sunea 40 Solar io