Publicidad
Idiomas disponibles
Idiomas disponibles
EN
8. TROUBLESHOOTING.
Anomalies
The machine suddenly stops
working after long use
During the welding, the
operator feels a tingling in
the hand.
Arc off
Your unit does not weld
correctly.
TIG
Instable arc
The electrode melts
9. WARRANTY.
Duration of the guarantee period:
• 36 months, according to R.D. 7/2021 of April 27, which modifies the consolidated text of the General Law for the
Defense of Consumers and Users (*) and other complementary laws, approved by R.D. 1/2007, of November 16.
• 12 months, for Companies or Professionals who use the product to carry out an activity for profit.
(*) Royal Decree 1/2007. Article 3. General concept of consumer and user.
For the purposes of this rule..., consumers or users are natural persons who act for a purpose unrelated to their
commercial, business, trade or profession.
Coverage: The guarantee requires the manufacturer CEVIK S.A. to repair or replace for free all components subject
to verified manufacturing defects. The CEVIK Assistance Service will be responsible for the repair or replacement in
the shortest possible time, compatibly with the internal commitments of the service, without any obligation of
compensation or reparation for direct or indirect damages.
The following are excluded from the guarantee:
- The consumption materials.
- Damages to people, animals or things caused by improper use, improper installation, modifications not approved
by the manufacturer, incompetence or non-observance of the rules contained in these instructions for use and
operation.
Causes
The machine is overheated
due to excessive use and
thermal protection
intervened
Defective electrical ground
system
Poor contact between earth
clamp and workpiece
Polarity error
-Default coming from the
tungsten electrode
-Too important gas flow
rate
Polarity error
40
Remedies
Wait that the LED TERM is off to
restat welding
Check the plug and grounding system
of the power supply.
-) Tighten the earth clamp and the
work piece surface and check
-) Clean or replace electrode and gas
nozzles
Check the torch or electrode holder
connection (+ or -)
-Use a tungsten electrode with the
adequate size
-Reduce gas flow rate
Check that the earth clamp is really
connected to "+"
Publicidad
