Publicidad
Idiomas disponibles
Idiomas disponibles
2.0 - CPI/OPI SWITCH
2.1 - CPI/OPI SWITCH TECHNICAL DATA
• Ambient temperature
• Switchable voltage
• Switchable current
• Protection rating
2.2 - INSTALLATION, CALIBRATION and WIRING
NOTE: if the product is supplied with the kit already assembled, the position of the microswitches is already calibrated and
set, therefore, for operation you simply need to connect them to the power supply. If calibration adjustments are required, it is
possible to act on the 2 screws (5) adjusting and fixing them so that with the valve closed/open they provide the desired signal.
CPI
• black cable: common
• white cable: signal with micro switch pressed (valve closed)
• red cable: signal with micro switch not pressed (valve open)
OPI
• black cable: common
• white cable: signal with micro switch pressed (valve closed)
• red cable: signal with micro switch not pressed (valve open)
After installation, open and close the solenoid valve (by resetting the valve and cutting off power) 2-3 times to make sure the
microswitch is signalling correctly both in CPI mode (valve closed) and in OPI mode (valve open).
: -20 ÷ +60 °C
: max 250 V (Vac)
: max 2 A
: IP67
10
Wiring diagram
SPDT
open valve / open contact
CPI
closed valve / closed contact
open valve / closed contact
OPI
closed valve / open contact
Publicidad
