Chamberlain Bilt C2212T Manual De Instalación página 39

Operation
Using your Door Control
MULTI-FUNCTION CONTROL PANEL
Push Bar
Command LED
LEARN Button
LOCK Button
LIGHT Button
SYNCHRONIZE THE DOOR CONTROL: To synchronize the
door control to the garage door opener, press the push bar
until the garage door opener activates (it may take up to 3
presses). Test the door control by pressing the push bar; each
press of the push bar will activate the garage door opener.
PUSH BAR: Press the push bar to open or close the door.
LEARN BUTTON: Use to program compatible remote
controls, wireless keyless entries and myQ
garage door opener.
LOCK: Prevents remote controls from working, while still
allowing activation from the door control and keyless entry.
(Factory setting is OFF.)
Turn ON:
Press and hold the LOCK button for 2 seconds. The com-
mand LED will flash as long as the lock feature is on.
Turn OFF:
Press and hold the LOCK button for 2 seconds. The
command LED will stop flashing and normal operation will
resume.
LIGHT BUTTON: Turns the garage door opener lights on or
off when pressed. Lights stay on for 4-1/2 minutes (factory
setting). The LIGHT button will not control the lights when the
door is in motion.
To change the amount of time the lights stay on:
Press and hold the LOCK button (approximately 10 seconds)
until the garage door opener lights flash. The time interval
is indicated by the number of times the garage door opener
lights flash:
1 flash is 1-1/2 minutes

2 flashes is 2-1/2 minutes

3 flashes is 3-1/2 minutes

4 flashes is 4-1/2 minutes

To cycle through the time intervals repeat the step above. If
the push bar LED is continuously blinking, the LOCK feature
needs to be turned off.
devices to the
®
PUSH BUTTON DOOR CONTROL
SYNCHRONIZE THE DOOR CONTROL: To synchronize
the door control to the garage door opener, press the push
button until the garage door opener activates (it may take up
to 3 presses).
PUSH BUTTON: Press the LIGHT button to turn the
garage door opener lights on or off. When the lights
are turned on they will stay on until the LIGHT button is
pressed again, or until the garage door opener is activated.
Once the garage door opener is activated the lights will
turn off after the specified period of time (the factory setting
is 4-1/2 minutes). The LIGHT button will not control the
lights when the door is in motion.
39
Push Button
LIGHT Button