Flex DD 2G 18.0-EC LD Instrucciones De Funcionamiento Originales página 20

NOTICE: To prevent gear damage, always
allow the tool to come to a complete stop
before changing gears.
Function-selection ring (PD 2G
18.0-EC LD only) and torque-
adjustment ring
WARNING!
Do not adjust the torque or function-selection
ring when the tool is running.
Your tool is equipped with a function-
selection ring (PD 2G 18.0-EC LD only)
and torque adjustment ring for various
applications. Move the ring depending on the
requirements of your task.
The proper setting depends on the job and
the type of bit, fastener, and the material you
will be working on. In general, use greater
torque for larger screws. If the torque is too
high, the screws may be damaged or broken.
DD 2G 18.0-EC LD (see figure K):
Your drill features 18 torque settings for
driving and 1 drilling setting. Output torque
will increase as the ring is rotated from 1 to
18.
Adjust the torque by rotating the torque-
adjustment ring. The higher the torque
setting, the more force the tool produces to
turn an object.
The drilling setting
to permit drilling and other heavy-duty
applications.
PD 2G 18.0-EC LD (See figure L):
Your hammer drill features 24 torque settings,
1 drilling setting, and 1 hammer drilling
setting. Output torque will increase as the
ring is rotated from 1 to 24.
The Drill setting
to permit (non-hammer) drilling and other
heavy-duty applications.
The Hammer Drilling setting
clutch to permit hammer drilling only.
NOTICE: Do not use the hammer drilling
setting for drilling in wood, metal, ceramic,
and plastic to prevent the drill/screw bit from
being damaged.
20
will lock the clutch
will lock the clutch
will lock the
DD 2G 18.0-EC LD / PD 2G 18.0-EC LD
LED light (see figure M)
Your tool is equipped with an LED light 5,
located on the base of the tool. This provides
additional light on the surface of the work
piece for operation in lower-light areas.
The LED light 5 will automatically turn on
with a slight squeeze on the variable-speed
trigger switch 4 before the tool starts running,
and will turn off approximately 10 seconds
after the variable-speed trigger switch 4 is
released.
The LED light will rapidly flash when the tool
and/or battery pack becomes overloaded or
too hot, and the internal sensors will turn the
tool off. Rest the tool for a while or place the
tool and battery pack separately under air
flow to cool them.
The LED light will flash more slowly to
indicate that the battery is at low-battery
capacity. Recharge the battery pack.
Switching on the power tool (see
figure N)
■ To switch the power tool on:
Press the trigger switch 4.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
■ To switch the power tool off:
Release the trigger switch 4.
WARNING!
To prevent accidental starting that could
cause serious personal injury, always
remove the battery pack from the tool when
assembling parts.
WARNING!
If any parts are damaged or missing, do
not operate this product until the parts are
replaced. Use of this product with damaged
or missing parts could result in serious
personal injury.
Drilling (see figure O)
WARNING!
Always wear safety goggles or safety
glasses with side shields during power
tool operation or when blowing dust. If
operation is dusty, also wear a dust mask.