Milwaukee CLL Manual Original página 8

WORKING IN MANUAL MODE
In manual mode the cross lasers self-leveling mechanism is disabled and the laser lines can be set at
any slope required.
1
Place the cross laser on a solid flat
vibration free surface or on a tripod.
2
Slide locking switch to position.
3
Same as in the self-leveling mode,
the cross laser will generate 2 laser
beams, but the laser beams are
interrupted every 8 seconds.
8 sec. 8 sec. 8 sec.
ENGLISH
4
Choose the beams that
you want to work with by
pushing operation push
button
5
Tilt the laser using a tripod and adjust
to the desired angle and height.
6
Before moving the cross laser, slide the locking
position. This will lock the
switch the OFF
pendulum and protect
your cross laser.
7