Descargar Imprimir esta página

GYS SUPER PRO SMART EV CHARGE Manual De Instrucciones página 11

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
Operating manual
Setting up a delayed charge
You can set a delayed start to the charge (off-peak/peak hours).
This process must be carried out before confirming the charge rating.
+
Memorising the charge rating
This function should only be considered if the electrical installation is suitable.
The charging cable must be disconnected from the vehicle.
The settings can be saved in the unit's memory so that they are not lost in the event of a power failure. After disconnecting,
the charger will automatically restart with the memorised charging current.
CONNEXION AU VÉHICULE
END OF CHARGE
The charge can be stopped at any time by pressing
Following a voluntary stop, some vehicles have a delay of up to one minute before allowing the charge
to be restarted or changed. Wait until
locked by the vehicle, no manipulation is possible.
Translation of the original
instructions
Press the «Current/Delay» button
Then use the arrows
hours, adjustable in hourly increments). Then press
After selecting & confirming the desired rating, press & hold
simultaniously. The LEDs
on the display.
To delete the stored data, repeat the same process of pressing and holding for
3 seconds. The LEDs
the screen.
Once the appropriate charge setting has been selected, connect the device to the
vehicle. The charger shows
The charge will then start automatically after a few seconds. The display will show
(charging in progress).
If charging has been delayed, the display shows alternately
time
until charging begins. It will indicate
When the vehicle is fully charged, the charger will show
If a vehicle decides to relaunch the charge, the charger will automatically restart itself.
Remove the charging cable from the vehicle.
. The Delay LED will light up.
to set the desired time delay (can be set from 1 to 24
&
flash, and the «Storage» message appears briefly
&
flash, and the «Clear» message appears briefly on
on the display (connected).
for 3 seconds.
flashes on the display. As long as it is fixed, the charger is
SUPER PRO SMART EV CHARGE
to confirm.
for 3 seconds
and the remaining
when charging is in progress.
on the display.
11

Publicidad

loading