GYS SUPER PRO SMART EV CHARGE Manual De Instrucciones página 10

Operating manual
DESCRIPTION
The SUPER PRO SMART EV CHARGE GYS is a Type 2 electric vehicle (EV) charging cable. It is suitable for daily
charging applications, and can be easily stored in a vehicle. It is IP55 rated, meaning that it is not vulnerable to dust or
rain. This charger is Type 2 compatible, and complies with European standards.
TYPE 2 (European Standard IEC 62196-2)
Audi A3 e-Tron, BMW 13, BMW i8, Chevrolet Spark, Mercedes B Class E-Celi,
Mercedes S500 PFIEV, Mercedes SLS EV, Mercedes Vito E-Cell Van, Porsche Panamera S PFIEV,
Renault Zoé, Renault Zoé 2013, Volkswagen e-Up, Volkswagen e-Golf, Volvo V60 PHEV ...
SINGLE-PHASE / THREE-PHASE
This device must be supplied with at least 3 cores (Neutral + Phase + Earth) or 5 cores (Neutral + 3
Phases + Earth) and is suitable for use in different types of sockets.
The SUPER PRO SMART EV CHARGE is supplied with two cables:
- 1 cable with a single-phase plug (16 A).
- 1 cable with a three-phase plug (32 A).
Connect the charging cable with the appropriate plug for the power supply system you are using. The charger auto-
matically recognises the selected plug and limits the charging current accordingly.
230 V
400 V
Maximum value with supplied single-phase accessory
Maximum value with supplied 3-phase accessory
CHOICE OF CHARGE CURRENT
+
10
Translation of the original
instructions
Power output table
10 A 13 A
2.3 kW 2.9 kW
6.9 kW 8.9 kW
Connect the unit to the power supply.
The cable automatically detects the type of socket to which it is connected, and regu-
lates the current accordingly.
Eg: if a 16A single-phase power outlet is detected upstream of the charging cable,
then the maximum current setting will be 16A.
However, it is possible to charge the vehicle with a lower amperage (10 A or 13 A)
if the electrical supply network requires it.
When the charger is switched on, select the charging current with the arrows
The charger always switches on with a default charging current of 10 A.
Press to confirm the desired current (if there is a calibration error, press
seconds and then repeat the process).

The display alternates between the selected current rating, and the "Ready" message.
The charger is now set up, and ready to be connected to a vehicle.
SUPER PRO SMART EV CHARGE
16 A
20 A
3.7 kW
4.6 kW
11 kW 14 kW
32 A
7.4 kW
22 kW
.
for 3