Instructions for use
You can activate or deactivate the cooker
hood by operating the functions shown in the
diagram.
Switch on the extractor fan a few minutes
before you start to cook in order to ensure that
a steady air flow has been established before
fumes appear.
Allow the extractor fan to run for several
minutes after you have finished cooking
(between 3 to 5 minutes) in order to expel all
the grease from the outlet duct. This prevents
the return of grease, smoke and smells.
1. Lighting
2. Selected speed increase
3. Selected speed decrease
4. Timer
Program the working time
• By pressing + / - turn on the hood and choose
the desired suction speed
• Press the Timer key. The light will start flashing.
• The duration of the programming time is
approximately 15 minutes.
• During the programmed time you can change
the suction speed.
• The Intensive speed is self-programmed and
will switch to speed 2 after approximately 7
minutes.
Fresh Function
•The fresh function consists on activating the
motor at speed 1 for ten minutos each hour. This
function will stay active for 24h or until it is manu-
ally turned off.
• To activate/deactivate this function, press the
" - " button for 3 seconds.
Cleaning and maintenance
During cleaning and maintenance work,
make sure the safety instructions are
complied with.
Cleaning the hood body
• If your kitchen hood is made of stainless
steel, use proprietary cleaners mentioned in
the product instructions.
• If your kitchen hood is painted, use lukewarm
water and a neutral soap.
• Never use metallic scourers, nor abrasive or
corrosive products.
• Dry the kitchen hood using a cloth that
does not produce fibres. Do not use vapour
cleaners.
• To remove the filters from their fittings, press
lightly on the locks and then pull them off.
Cleaning the metal filters
• To remove the filters from their fittings, press
lightly on the locks and then pull them off.
• The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher.
In this case, it is advisable to stack them
vertically to avoid food residues to stick to
them.
• Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this
will not affect its fat retention capacity.
• Once clean, leave them to dry off and then fit
them onto the kitchen hood.