Emos P5723 Guia De Inicio Rapido página 3

Pairing of the push button and the door chime
1. Insert 3× 1.5 V AA batteries into the door chime, hear a melody, the door chime is ready for pair-
ing. Do not mix together old and new or different types of batteries (Alkaline, carbon-zinc and
nickel-cadmium), do not use rechargeable batteries!
2. Press the push button on the button (transmitter), hear a melody, the devices will be matched.
3. For pairing of other buttons, repeat step 2.
4. Pushbuttons can be matched within 30 seconds after inserting the battery.
5. If you want to pair another buttons later, follow step 1 and 2.
6. This allows you to progressively pair up to 8 buttons.
Erasing the memory of paired buttons
1. Remove the rear part of the push button cover.
2. Set the chime to the pairing mode – depending from the door chime type, remove the battery
and reinsert or disconnect the chime from the 230 V socket and reconnect.
3. Within 30 seconds push the S2 button on the rear of the push button (transmitter).
4. A melody will sound – the memory of all matched buttons will be erased.
Melody choice
Using a suitable thin (not sharp) object such as a pencil, press the button A repeatedly.
Each time you will hear a different melody – the last played melody will be set.
The change of the melody can be done at any time when the doorbell is charged.
Note: The transmission range (max. 100 m) is influenced by local conditions such as number of walls
through which the signal must pass through, metal door frames and other elements that affect
the transmission of radio signals (presence of other radio devices operating at a similar frequency,
e.g. wireless thermometers, door drivers etc.). The transmission range can rapidly decrease under
influence of these factors.
Troubleshooting
The door chime does not ring
• Door chime may be outside its range.
• Adjust the distance between the push button and the home door chime; the range can be
affected by local conditions.
• Batteries in the push button can be discharged.
• Replace the battery paying attention to the polarity of the inserted battery.
• Door chime has no power.
Care and Maintenance
Wireless digital door chime is a sensitive electronic device therefore take the following precautions:
• Door chime (receiver) is designed for an indoor use in dry areas.
• Door chime must be located in an easily accessible area for easy handling and disconnection.
• Occasionally check the function of the door chime and change the battery. Use only a high quality
alkaline battery with prescribed parameters.
• If you do not use the door chime for a long time, remove the battery from the push button.
• Do not expose the push button and the door chime to excessive vibrations and shocks.
• Do not expose the push button and the door chime to excessive heat and direct sunlight or moisture.
• Use a soft, damp cloth with a little of detergent for cleaning, do not use aggressive cleaning
agents or solvents.
This device is not intended for use by a person (including children) whom a reduced physical, sense or
mental inability or a lack of experience and knowledge inhibits from a safe use of the device, if they
are not supervised or have not been instructed about the use of the device by a person responsible
for their safety. It is necessary to supervise children to ensure that they do not play with the device.
Do not dispose with domestic waste. Use special collection points for sorted waste. Contact
local authorities for information about collection points. If the electronic devices would be
disposed on landfill, dangerous substances may reach groundwater and subsequently food
chain, where it could affect human health.
3