Publicidad
Idiomas disponibles
Idiomas disponibles
resistance of minimum 1.5 Nm / 13 in-lb.
The locknut must be replaced after it has
been put on approximately 10 times.
CAUTION:
thread. To tighten the locknut to much can
cause damage to the threads.
The locknut secures the cutting attachment on the
output shaft. Protect your hand from injury when
assembling, use the cutting attachment guard as
protection when tightening with a socket wrench.
1. When fitting, tighten the locknut in the opposite
direction to the direction of rotation of the cutting
attachment. To remove it, undo the locknut in the
same direction as the cutting attachment rotates.
2. Tighten the locknut using a socket wrench to 35-50
Nm / 26-37 ft-lbs.
Cutting equipment
Select correct cutting equipment and do maintenance on
the cutting equipment to:
•
Get maximum cutting performance.
•
Increase lifetime of the cutting equipment.
WARNING:
attachments and guards recommended by
Introduction
WARNING:
safety chapter before you assemble the
product.
1847 - 001 - 28.11.2022
The locknut has a left-hand
Only use the cutting
Assembly
Read and understand the
Husqvarna. Refer to
20 .
WARNING:
attachment may increase the risk of
accidents.
WARNING:
before you do the work on the cutting
attachment. This continues to rotate after
you release the power trigger. Make sure
that the cutting attachment has stopped fully
and remove the battery before you start the
work on it.
WARNING:
gloves when you attach, examine or clean
the cutting equipment.
Safety instructions for maintenance
WARNING:
instructions that follow before you do
maintenance on the product.
•
Remove the battery before you do maintenance,
other checks or assemble the product.
•
The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
•
Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
•
If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
•
Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
•
Only use original spare parts.
To assemble the bevel gear
1. Insert the driveshaft into the bevel gearbox housing.
Turn the cutting attachment so that the shaft
engages in the bevel gear.
2. Attach the bevel gear box to the shaft tube aligning
the positioning holes.
Accessories on page
A defective cutting
Always stop the engine
Always wear heavy duty
Read the warning
11
Publicidad
