Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
WARNING:
safety chapter before you use the product.
Before you operate the product
•
Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
•
Do a general inspection of the product.
•
Do the safety inspections, maintenance and
servicing that are given in this manual.
•
Make sure that all nuts and screws are tight.
•
Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged before you start the product.
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click.
CAUTION:
move easily into the battery holder, the
14
Operation
Read and understand the
Only use Husqvarna
If the battery does not
battery is not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed correctly.
To start the product
1. Put the product in the start position.
2. Push and hold the start button until the green LED
comes on.
3. Use the power trigger to control the speed.
To adjust the loop handle
1. Loosen the knob and adjust the loop handle to an
applicable position.
Note:
Make sure not to attach or move the loop
handle onto the warning decals on the two-piece
shaft.
2. Tighten the knob.
Automatic shutdown function
The product has a shutdown function that stops the
product if the product is not used. The green LED for
start/stop indication goes off and the product stops after
180 seconds.
1847 - 001 - 28.11.2022
Publicidad
