Publicidad
Idiomas disponibles
Idiomas disponibles
b) For model 525iES:
2. Set the desired cutting depth.
3. Tighten the wing nut.
To install the front guard
1. Install the front guard on the front of the cutting
attachment guard.
2. Attach the bolt and tighten it.
To assemble the loop handle
1. Attach the loop handle onto the shaft.
1847 - 001 - 28.11.2022
2. Move the spacer into the slot of the loop handle.
3. Install the nut, the knob and the screw, do not make
it too tight.
4. Adjust the product to a comfortable position. Refer to
To adjust the loop handle on page 14 .
5. Tighten the bolt.
To install the harness support hook
1. Install the harness support hook between the loop
handle and the throttle handle.
Note:
Do not put the support hook on the decal.
2. Adjust the ring to make the product balanced, and
easy to use.
To adjust the harness
1. Put on the harness.
2. Attach the harness to the harness support hook.
3. Adjust the length of the harness until the harness
support hook is in level with your right hip.
Battery information
Refer to the operator's manual of the battery for
information about how to use the battery.
13
Publicidad
