Husqvarna FS 305 Manual De Usuario página 11

4. Lift the pointer (A) to an upright position.
A
C
5. Loosen the front nut (B) on the blade guard.
6. Lift the blade guard (C).
7. Remove the blade screw (D).
D
8. Remove the blade flange (E).
9. Examine the blade screw (D), the blade flange (E),
the inner flange (F) and the locking pin (G).
a) Clean all contact surfaces between the blade
and the blade flange. Clean the blade shaft bolt
threads and the contact surfaces of the blade
shaft bolt.
b) Replace worn or damaged parts.
WARNING:
can prevent correct installation of the
cutting blade.
1919 - 002 - 23.01.2023
E
Damaged or dirty parts
10. Install the cutting blade on the inner flange (F).
B
E
D
11. Make sure that the cutting blade rotates in the
direction of the arrows shown on the cutting blade.
F
12. Install the blade flange (E) and the blade screw (D).
Make sure that the locking pin (G) on the inner
flange, goes through the cutting blade and into the
blade flange (E).
13. Hold and push the cutting blade in reverse direction
of rotation. At the same time tighten the blade screw
(D).
14. Turn the cutting depth wheel counterclockwise to
lower the cutting blade.
15. Tighten the blade screw (D) to minimum 40-45 Nm
with the supplied wrench. The resistance between
the cutting blade and the ground keeps the cutting
blade in position.
16. Lower the blade guard.
17. Start the product and listen for unusual sounds. If
there are unusual sounds, remove the cutting blade.
a) Examine the cutting blade for damages.
b) Install the cutting blade again. Replace the
cutting blade if it is damaged.
F
G
CAUTION:
Risk of damage to the
cutting blade if it is installed opposite the
direction of rotation.
11