Husqvarna FS 305 Manual De Usuario página 10

• Decrease the cutting depth and the engine speed
for a short time to sharpen the diamonds on the
diamond blade.
Diamond blades for wet cutting
WARNING:
dimension that is specified for the current
blade dimension. Do not use blade flanges
that are damaged.
During the operation, the friction causes the diamond
blade to become very hot. If the diamond blade
becomes too hot, it will decrease the blade tension or
make the core crack.
Let the diamond blade become cool before you touch it.
• Diamond blades for wet cutting must be used with
water to keep the diamond blade core and segments
cool during cutting. Diamond blades for wet cutting
can not be used dry.
• If you use diamond blades for wet cutting without
water, the diamond blade can become too hot. This
gives bad performance, blade damage and is a
safety risk.
To fill fuel
WARNING:
flammable. Be careful and refuel outdoors.
Fuel safety on page 8 .
Refer to
CAUTION:
type. Incorrect fuel type causes damage to
the product.
• Use gasoline of the correct type. Refer to
data on page 18 . For more information about the
fuel, refer to the engine manual supplied by the
engine manufacturer.
To adjust the handle height
The height of the handle can be adjusted to the correct
height.
1. Loosen the levers (M).
10
Always use a blade flange
Gasoline is very
Always use correct fuel
Technical
2. Set the position for the necessary work height.
3. Tighten the levers (M).
To use the track widener
The track widener makes the product more stable.
1. Loosen the screw (A) for the track widener.
A
2. Pull the right rear wheel out until it stops.
3. Tighten the screw (A) for the track widener.
To install a cutting blade
1. Make sure that the engine ON/OFF switch is in its
OFF position.
2. Turn the cutting depth wheel clockwise to fully lift the
cutting blade. Push the lever to lock the cutting depth
wheel.
WARNING:
depth wheel when the cutting depth
wheel is not in use.
3. Stop the water supply and disconnect the water hose
from the blade guard.
Always lock the cutting
1919 - 002 - 23.01.2023