Husqvarna FS 305 Manual De Usuario página 15

To clean the product
WARNING:
When you clean the product, dirt and
harmful material can eject from the product.
CAUTION:
decreases the performance of the product
and can cause the engine to become too
hot.
• Let the product become cool before you clean it.
• Do not clean electrical components with water.
• Use a weak cleaning agent. Put on protective gloves
to prevent skin irritation.
• Always clean all the equipment at the end of the
work day. Do not use a high-pressure washer to
clean the product.
• Remove blockage from all air openings.
• Clean all outlets, connections and cables with a dry
cloth.
• Remove unwanted material that causes a blockage
to the water supply holes in the blade guard.
• Clean around the fuel tank cap.
To do a general inspection
• Make sure that the nuts and screws on the product
are tightened.
• Make sure that the cables on the product are not in a
position where they can become damaged.
• Make sure that there are no fuel or oil leaks.
• Make sure that the seals for the fuel tank cap are not
damaged.
• Examine the fuel hose. Replace the fuel hose if it is
damaged or worn.
• Examine the water hoses for leakage. Do not
operate a product that has damaged water hoses.
To adjust the tension of the drive belt
1. Loosen the 2 nuts (S) and remove the drive belt
cover.
1919 - 002 - 23.01.2023
Use protective glasses.
A blocked air intake
2. Make sure that the drive belt is not damaged.
3. Loosen the screws that keep the engine in position.
4. Turn the tension nuts ¼ (N) turn clockwise to
increase the tension of the drive belt.
CAUTION:
tension of the drive belt too much.
5. Make sure that the drive belt pulleys are aligned.
6. Tighten the screws that keep the engine in position.
7. Turn the tension nuts 2 turns counterclockwise to
prevent that the tension screw touches the engine
block.
8. Install the drive belt cover and tighten the 2 nuts.
To lubricate the product
Lubricate the components that follow. Lubricate until the
grease can be seen at the edges. For correct grease,
Technical data on page 18 .
refer to
1. Apply some grease to the grease nipples of the lever
for cutting depth adjustment.
2. Turn the cutting depth wheel clockwise and
counterclockwise again and again and lubricate
equally.
To do a check of the engine oil level
1. Make sure that the cutting blade is removed and that
the product is level when you examine the engine oil
level.
2. Remove the dipstick from the oil tank.
3. Clean the oil from the dipstick.
4. Put the dipstick back fully into the oil tank.
5. Remove the dipstick.
6. Examine the oil level on the dipstick. Make sure that
the level of engine oil is between the marks on the
dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
on page 18 for correct engine oil type.
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and faster to drain.
WARNING:
for more than 1–2 minutes before you drain
the engine oil. The engine oil becomes very
hot and can cause burn injuries. Let the
engine become cool before you drain the
engine oil.
Do not increase the
Technical data
Do not operate the engine
15