Husqvarna FS 305 Manual De Usuario página 9

• Only do the maintenance as given in this operator's
manual. Let an approved service center do all other
servicing.
• Remove all tools from the product before you start
the engine after maintenance. Loose tools or tools
attached to rotating parts can eject and cause injury.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the instructions that are supplied with the
cutting blade by the cutting blade manufacturer.
• Read the operator's manual supplied by the engine
manufacturer.
• Before each operation of the product, do these
steps:
a) Do the daily maintenance. Refer to
schedule on page 14 .
b) Make line marks for all cuts. Prepare the
operation sequence carefully to prevent injury
and damage.
c) Make sure that the cutting blade is correctly
installed. Refer to
d) Adjust the handle to an applicable operation
position. Refer to
page 10 .
e) Fill the water tank or connect external water
supply to the water tap.
f) Make sure that the water tap is open. Each side
of the cutting blade must have sufficient supply of
water.
g) Make sure that the pointer is aligned with the
cutting blade. Refer to
the cutting blade on page 12 .
h) Turn the machine stop button clockwise to make
sure that the machine stop button is disengaged.
Cutting blades
WARNING:
for other materials than which it is made for.
WARNING:
for wet cutting. The diamond blade must be
applicable to the same speed or a higher
speed than the value given on the product
type plate. Only use diamond blades that
are in compliance with national or regional
1919 - 002 - 23.01.2023
Read and understand the
Maintenance
Maintenance on page 14 .
To adjust the handle height on
To align the pointer with
Do not use a cutting blade
Only use diamond blades
• Let an approved service center do servicing on the
product regularly.
Operation
standards, for example EN13236 or ANSI
B7.1.
The cutting blade manufacturer gives warnings and
recommendations for the operation and correct
maintenance of the cutting blade. Those warnings are
supplied with the cutting blade.
Diamond blades
WARNING:
direction of rotation for the diamond blade
shown on the diamond blade aligns with the
direction of rotation shown on the product.
CAUTION:
diamond blade.
There is a wide range of diamond blades that is used
for different operations. From new made concrete to
concrete and asphalt that has become hard and for
different hardness classes.
Diamond blades has a steel core with segments that are
made of industrial diamonds.
Water cooling system
Always use water during operation to keep the
temperature of the diamond blades down. The water
cooling system also increases the lifetime of the
diamond blades and prevents dust buildup.
Make sure that the water supply is not clogged.
To sharpen the diamond blades
Diamond blades can become blunt if you use an
incorrect feeding pressure or when you cut materials
such as hard reinforced concrete. If you use a blunt
diamond blade it becomes too hot, which can cause the
diamond segments to come loose.
Make sure that the
Always use a sharp
9