Publicidad
Idiomas disponibles
Idiomas disponibles
When the outdoor button is pushed, the first receiver will ring first, then forward
the signal to the second receiver, which will then also ring.
All paired receivers will play the same ringtone upon ringing.
Repeater mode is indicated upon sending signal to the next receiver by
flashing of red LED.
You can pair an unlimited number of receivers into repeater mode.
Repeat the same procedure (activating pairing mode) for pairing each additional
new receiver and the last receiver in the line (switching the
to position I).
All paired receivers are in parallel connection.
It is thus necessary that each paired receiver is powered throughout the entire
course of its operation for the signal extender function to work properly.
Deactivating Signal Extender Mode
Switch the
The receiver will not forward signal to other paired receivers in the line upon
ringing – the receivers after it will not ring.
Installing the Chime (Receiver)
1. The chime is designed for indoor use only and is powered by 3× 1.5 V
AA batteries.
2. The transmission range (max. 120 m) is influenced by local conditions,
such as the number of walls through which the signal passes, metal door
frames and other elements which affect the transmission of radio signals
(presence of other radio devices operating at a similar frequency, such
as wireless thermometers, gate controls etc.). Transmission range can
decrease drastically due to these factors.
Troubleshooting
The chime is not ringing:
• The chime may be out of range.
• Change the distance between the button and the doorbell; the range
may be affected by local conditions.
• The chime battery may be flat.
• Replace the battery. Make sure it has the correct polarity. Pair the
button with the chime again.
• The chime is not powered. The batteries in the chime may be flat.
• Replace the batteries. Make sure it has the correct polarity. Pair the
button with the chime again.
button to position O on the chosen receiver.
6
button
Publicidad
