Publicidad
Idiomas disponibles
Idiomas disponibles
are designed for a minimum operating pressure of 6 bar,
are replaced regularly at preventative maintenance,
have an oil resistant inner surface and an abrasion-resistant outer surface,
are proved and specified to be non-conductive when being used next to electric conductors.
Always use hoses, lubricating oil and antifreeze lubricants, which meet the local safety
requirements for use in areas exposed to explosion hazards.
Connecting the air supply to the pneumatic core drill
Remove the locking cap from the air connection 3. Connect the pneumatic hose (claw
connector and pneumatic hose not included in the product).
General
Basically, you differentiate between "freehand drilling" and "drilling with a drill rig". The two
different operating modes are described below.
Assembly and disassembly tools are part of the full scope as well:
Wrench
AF 22
Wrench AF 32
Wrench AF 41
Freehand drilling
Mount the spot-drilling support onto the centering collar to ensure precise pointing.
Screw on the desired drill bit (up to max. Ø82 mm − approx. 3 inches).
(Manual tightening is sufficient, because the drill bit will automatically fasten during drilling.)
Connect the tool to water supply, using the "Gardena" hose couplings.
Connect the tool to the pneumatic supply.
34
Exhaust
Air inlet
Fig.2
STARTUP
Publicidad
