EGAmaster 79303 Manual De Instrucciones página 45

Idiomas disponibles

NOTICE – Special instructions apply for the repair of explosion-proof machines.

Retrofits or modifications of the machine need the manufacturer's acceptance.

The explosion-proof machine is designed in the type of protection '' c''

constructive safety.

All work executed on the machine, influencing the explosion protection, e. g.

repairs with mechanical machining, require an approval of an authorized expert

or have to be done by the manufacturer.

The internal structure must remain unmodified.

Unused machines and machine tools should be kept in a dry, closed room.

Keep them free from damaging influences such as damp, frost or large temperature

fluctuations as well as mechanical damage. Always store the machine in a way that important

machine instructions, e. g. on stickers and signs, are legible.

Dispose of machine and worn out/defective machine tools according the local/national

regulations. Fully disassemble the machine for the necessary disposal. Separate materials

according to local environmental specifications. Dispose of environmentally hazardous greasing,

cooling or cleaning agents in order to avoid environmental contamination.

When working on or with the equipment, it is imperative to observe all legal

requirements in regards to waste-disposal and proper recycling. In particular

during installation, repair and maintenance work, water damaging agents, such as

• lubricating grease and oil, coolant, solvent containing cleaning agents

Must not leak into the ground or reach the sewage system!

These materials must be stored, transported, contained and disposed of in

suitable containers!

The following table shows possible problems and their causes:

Problem, cause, remedy

Problem

Machine does not start Not connected to compressed air

Machine is rotating too

slowly

Gear makes noises