Publicidad
Idiomas disponibles
Idiomas disponibles
(83),
Fig.6.
assembly with the right foot bar (9).
Perform the same assembly on the
right side.
Put the bushing (86) on the left foot bar
(8) using the screw (32), Fig.7.
Perform the same assembly on the
right side.
6.-
FITTING
BARS.-
Put he cover (98) on the axis. Then fit
the left focus bar (5) on the axis using
the screw (35) and the washer (49),
Fig.8.
Connect the left pedal tube (11) with
the left focus bar (5) and secure it with
the screw (33), the bushing (62), the
washer (50) and the nut (58), Fig.8.
Fit the cover (97) using the screws
(46).
Fit the upper bar cover (102) on the left
upper focus bar (14) and then connect
it with the left lower focus bar (5) using
the screws (36) and the nuts (58),
Fig.8.
Perform the same assemble with the
right focus bar.
Put the lower bar covers (90) and (91)
on the left focus bar (5) using the
screws (83), Fig.9.
Perform the same assemble with the
right focus bar.
Perform
the
THE
FOCUS
same
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This can
be achieved by screwing the adjustable
feet (38) up or down, as shown in
Fig.10.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (101),
as shown in Fig.10, which make it
easier to move. The two wheels at the
front of the unit make it easier to place
the unit in to any chosen position by
lifting the rear slightly
Store your unit in a dry place,
preferably not subject to changes in
temperature.
MAINS CONNECTION.-
Insert the jack (m) for the transformer
into the connection hole on the main
body (k) (bottom, rear of the machine)
and then plug the transformer (114)
into a 230 V mains supply, Fig.11.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
17
Publicidad
